2) Click OK.
5. Enable the event so that when the event is detected, en event
will be sent to the client and the linkage actions will be
triggered.
6. Optional: Click Copy to... to copy the event settings to other
access control device, alarm input, door, or card reader.
7.6.2 Configure Device Actions for Access Event
You can set the access control device's linkage actions for the
access control device's triggered event. After that, when an event
is triggered, it can trigger the alarm output, buzzer on access
controller, and other actions.
Steps
Note
The linkage actions should be supported by the device.
1. Click Access Control → Linkage Configuration .
2. Select the access control device from the list on the left.
3. Click Add to add a new linkage.
4. Select Event Linkage as the event source.
5. select the event type and detailed event to set the linkage.
6. In the Linkage Target area, set the property target to enable
this action.
Buzzer on Controller
The audible warning of access control device will be
triggered.
Capture
An event-related picture will be captured when the selected
event happens.
Recording
An event-related picture will be captured when the selected
event happens.
Note
The device should support recording.
Buzzer on Reader
The audible warning of card reader will be triggered.
Alarm Output
The alarm output will be triggered for notification when the
selected event happens
Alarm Input
Arm or disarm the alarm input.
Note
The device should support alarm input function.
Access Point
The door status of open, close, remain open, or remain close
will be triggered.
91
