Fuji Xerox apeosport-IV 6080, Administrator'S Manual

Page: 611 / 705

ESC/P-K Emulation
611
Ap
pe
ndix
16
ESCP switch 55
(Text quality)
Sets the Text Quality mode to high quality or draft.
[0] (Default)
: High Quality
[1] : Draft
Important • Since the default value is selected for the [Text Quality], [Reduced
Characters], [Character Code Table], [Page Length], and [1-inch
Perforation Skip] features, their settings will not be affected when an
extended command is received.
Note • Changing settings does not change actual printing quality.
• This setting affect the Text Quality selection commands. For more
information on the Text Quality selection commands, contact our
Customer Support Center.
56
(Reduced
characters)
Reduces the size of single-byte alphanumeric characters when printing.
Sets whether to reduce their sizes or to print them at a scale of 100%.
[0] (Default)
: Off
[1] : On
58
(Page length)
Sets the length of a page (printable area) to 11 inches or 12 inches.
[0] (Default)
: 11 inches
[1] : 12 inches
59
(1-Inch
perforation skip)
Sets whether or not to leave a 1-inch space between pages.
[0] (Default)
: Off
[1] : On
Important • This is effective only when CSF under [Paper Position] is set to [Off].
60
(Paper feed
position)
Sets the position to start printing at 8.5 mm or 22 mm below the top edge
of paper.
[0] (Default)
: 8.5 mm
[1] : 22 mm
61
(CR feature)
Sets the action to be executed when a CR command is received.
[0] (Default)
: Carriage return
[1] : Carriage return and linefeed
Position
adjustment 15
(Vertical
position
adjustment)
Adjusts the printing position vertically or horizontally, and changes the
positions of the margins.
[0] (Default)
: Off
[1-500] : -250 to +250 mm
Important • Data outside the printable area is not printed regardless of the
adjustment of the print position. In addition, data moved outside the
printable area as a result of adjusting the print position is not printed.
16
(Horizontal
position
adjustment)
Escape
sequence 62
(Escape
sequence)
A normal extended command is specified starting with hexadecimal 1BH
ESC as the escape sequence identifying the command, followed by ;
(3BH).
When you cannot use a semicolon or ESC code with the host computer,
you can use a special string instead as an escape sequence. This setting
specifies whether or not to enable the escape sequence replacement
feature. When enabling, specify the escape sequence with item 63.
[0] (Default)
: Disabled
[1] : Enabled
For more information on extended commands, contact our Customer Support
Center.
63
(Escape
sequence
character)
To control an extended command with a text code, you must specify an
escape sequence (the first two bytes) of the extended command.
Enter two characters using the keyboard displayed on the screen.
[&%] (Default) : 0x21 - 0x7e
Setting Item
Item
Number
Value