Fuji Xerox apeosport-IV 6080, Administrator'S Manual

Page: 661 / 705

Notes and Restrictions
661
Ap
pe
ndix
16
„ Thumbnail View
z
Files in a folder may not be displayed in thumbnail view in the following cases. In
those cases, display them in list view.
- Some file is not displayed in thumbnail view even though it is stored in the folder.
- Characters and images are not correctly displayed because they are scaled down
from the actual sizes.
z
The orientation of an image displayed in thumbnail view depends on which
orientation the document was stored in.
z
If the power is cut off immediately after a scanned file is stored in a folder, or if the
hard disk space is insufficient to display thumbnails, files in the folder may not be
displayed in thumbnail view. In that case, display them in list view.
„ FTP Transmission for Scan to PC
z
By factory default, [Passive Mode] is selected as a transfer mode to send scanned
data via FTP from the machine.
z
You can switch the FTP transfer mode using CentreWare Internet Services, but
cannot switch the mode per job or per destination FTP server.
z
Depending on your network environment, operations may not be performed properly
unless the FTP transfer mode is switched from [Passive Mode] to [Active Mode].
When [IP Filtering] is enabled, make sure to switch the FTP transfer mode to [Active
Mode].
In [Passive Mode], the server permits a client to connect to the port for the data
transfer so that the client starts the connection. [Passive Mode] is commonly used
and also has lower security risk than [Active Mode].
In [Active Mode], a client notifies the server of the port number for the data transfer
so that the server starts the connection. [Active Mode] may incur a security risk such
as impersonation by third parties. In addition, the proper connection may not be
available in a firewall environment. In such a case, select [Passive Mode].
„ SMB Transfer for Scan to PC
If you use Mac OS X v10.7 Lion, contact our Customer Support Center and ask if your
operating system is supported.
„ Store to WSD
z
When the WSD scan port is not activated, [Store to WSD] button is not displayed in
the [Services Home] screen. Enable the WSD scan port to use the Store to WSD
feature on the machine.
z
Store to WSD feature requires the scanner driver included as standard in Windows
Vista Service Pack 2 or later. When an appropriate operation system is installed, you
can operate scan using [Windows Fax and Scan] or [From scanner or camera] in
[Microsoft Paint].
z
[Next Original] is not displayed when using WSD scan.
z
You cannot execute multiple jobs simultaneously. If you execute a job during the
scan job, the latter job is not accepted.
z
When using WSD scan, you cannot change layout settings by the machine.
Configure the settings on the computer using the scanner driver included as
standard in Windows.