Fuji Xerox apeosport-IV 6080, Administrator'S Manual

Page: 180 / 705

5 Tools
180
T
ools
5
SMB Server Settings
„ SMB Server Setup
Select the server specification method from [By Domain Name] and [By Domain & Server
Names/IP Address].
According to the option you selected here, set [Domain Name] and [Server Name/IP Address]
for SMB servers 1 to 5 respectively. The setting for SMB server 1 is used as the default
setting for authentication.
„ Domain Name
Enter the domain name of the server. Up to 64 characters are allowed.
This setting is mandatory regardless of the SMB server specification method selected for
[SMB Server Setup].
Important • Use the NetBIOS or Active Directory domain name for the domain name.
„ Server Name/IP Address
Enter the server name or IP address.
This setting is valid when [SMB Server Setup] is set to [By Domain & Server Names/IP
Address].
Important • Use the NetBIOS computer name or full computer name with DNS suffix for the server
name.
• For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value
from 0 to 255.
Security Settings
Set the security settings.
SSL/TLS Settings
Configure the SSL/TLS settings.
„ Device Certificate - Server
Select a certificate for HTTP SSL/TLS communications.
„ HTTP - SSL/TLS Communication
Select whether or not to enable HTTP SSL/TLS communications.
„ HTTP - SSL/TLS Port Number
Set the port number used for HTTP SSL/TLS communication from 1 to 65535.
The default value is 443.
Important • Do not use the numbers assigned to the other ports.
„ LDAP - SSL/TLS Communication
Set whether or not to enable the SSL/TLS communications for authentication and searches.
If you enable the LDAP SSL/TLS communications, you must set [Primary Server Port
Number] and [Secondary Server Port Number] under [LDAP Server/Directory Service
Settings].
The port number for SSL/TLS communications of the LDAP directory server is normally set to
636.
„
SMTP-SSL/TLS Communication
Configure the SSL/TLS communications.
z
Disabled
The machine does not communicate in SSL/TLS.
z
STARTTLS (If Available)
The machine verifies the certificate and communicates in SSL/TLS. If the verification fails, the
machine does not communicate in SSL/TLS.