Fuji Xerox apeosport-IV 6080, Administrator'S Manual

Page: 70 / 705

3 Maintenance
70
M
ai
n
te
na
nc
e
3
4
Insert the emptied hole punch waste
container into the finisher until it stops.
5
Close the finisher front door.
Note • If the finisher front door is not completely closed, a message will appear and the machine will
remain paused.
Emptying the Hole Punch Waste Container (for D2-Staple-Finisher or D2-
Staple-Finisher with Booklet Maker)
When the D2-Staple-Finisher (optional) or the D2-Staple-Finisher with Booklet Maker
(optional) is installed and the hole punch waste container becomes full, a message
appears on the touch screen. When the message appears, empty the hole punch waste
container as instructed.
Make sure to discard all paper chads when emptying the hole punch waste container.
Not doing so will cause the container to fill up before the message telling you to empty
the container appears again, and this can cause machine malfunction.
Important • Empty the hole punch waste container when the machine is on. If you empty the container
while the machine is off, the machine does not recognize that the container has been
emptied.
• When the machine is in Energy Saver mode, exit Energy Saver mode by pressing the
<Energy Saver> button and the <Machine Status> button on the control panel before you
empty the hole punch waste container.
• When you empty the hole punch waste container, press the <Machine Status> button and
check the current status for the hole punch waste container even when the control panel is
lit.
1
Make sure that the machine is not operating,
and open the finisher right door.
2
Pull out the hole punch waste container [R4].
[R4]