Ezgo 1600xd, Repair Manual

Page: 399 / 416

12
-61
SUUV-W00 Apr. 2011
SAFETY
FIRST
GENERAL
ENGINE
CVT
TRANSMISSION
CHASSIS
REAR AXLE
BRAKE
FRONT AXLE
STEERING
HYDRAULIC
ELECTRIC
INDEX
Check point Check item (method) Remarks
6. Fuse 1. Check method
- Fuse 3 for open circuit
- If it has a open circuit, replace it with new
one with rated capacity (5A).
(Fuse No.3)
UUVWA63B
7. Display unit 1. Check the following
- Check if the voltage at the No. 1 terminal is
12 V with the key switch in "ON" position
- Check if the output voltage at the No. 7
terminal is 12 V with the coolant temperature
below 30°C (86°F)
- Check if the output voltage between No. 1
terminal and ground is 12 V (for 8 seconds)
→
Preheat lamp (No. 2)
# #
Suhkhdw#
Odpsv
Dowhuqdwru#
fkdujlqj#vljqdo
V
tart switch ST
Pdqxdo#
suhkhdw#
vljqdo
GND
Idq#prwru#
rxwsxw
Suhkhdw#uhod|
Hohfwurqlf#
slfnxs#vljqdo
16 Hz output
Frrodqw#
whpshudwxuh#
vhqvru
1 sec. output
Vshhg#vljqdo#
rxwsxw
UUVWA91B
8. Glow plug 1. Glow plug ring terminal
- The resistance between the terminal and
ground (chassis) is approx. 0.43
Ω
1. If the measured resistance is “
∞
”: open
circuit
2. If the measured resistance is “0”: short
circuit
2. Check the voltage when in operation
- With the plug automatically preheated, the
voltage between the glow plug and ground
should be 12 V. (Voltage fl uctuation by
operating time: 8~12V)
UUVWA72A
ELECTRIC SYSTEM - DIAGNOSIS AND TROUBLESHOOTING
UTV(EZGO향)_12_ELECTRIC SYSTEM.in섹션1:61 섹션1:61 UTV(EZGO향)_12_ELECTRIC SYSTEM.in섹션1:61 섹션1:61 2011-04-04 오후 4:37:05 2011-04-04 오후 4:37:05