Ezgo 1600xd, Repair Manual

Page: 99 / 416

3
-61
SUUV-W00 Apr. 2011
SAFETY
FIRST
GENERAL
ENGINE
CVT
TRANSMISSION
CHASSIS
REAR AXLE
BRAKE
FRONT AXLE
STEERING
HYDRAULIC
ELECTRIC
INDEX
UUVW299A
When installing the fuel injection pump, the pump
control rack (1) should be on the side of the fork le-
ver 1 (2). 3.
UUVW2A1A
The fuel injection pump mounting bolts and nuts
should be tightened in order as shown in the fi gure to
the specifi ed torque in several steps.
Bolt and nut
tightening torque ............ 23.5 ~ 27.4 Nm
2.4 ~ 2.8 kgf-m
17.3 ~ 20.2 lb-ft
4.
1. Apply the liquid gasket (Three bond 1215, 1104 or
equivalent) on the pump installation surface of the
cylinder block.
2. Install the shims same as the previous state.
ASSEMBLY
●
6.2.3 SPEED CONTROL LEVER PLATE AND
GOVERNOR SPRING
UUVW267A
UUVW268A
Unscrew the three mounting bolts (M6, 1) and
one nut (M6, 2) for the speed control plate cover
to open the cover. Then, disconnect the governor
spring. 1.
UUVW269A
Remove the injection pump cover to check the con-
dition of the governor fork lever (1) and spring (2). 2.
DISASSEMBLY
●
ENGINE - DISASSEMBLY, SERVICE AND ASSEMBLY
UTV(EZGO향)_03_ENGINE.indd 61 UTV(EZGO향)_03_ENGINE.indd 61 2011-04-04 오후 3:43:19 2011-04-04 오후 3:43:19