Ezgo 1600xd, Repair Manual

Page: 393 / 416

12
-55
SUUV-W00 Apr. 2011
SAFETY
FIRST
GENERAL
ENGINE
CVT
TRANSMISSION
CHASSIS
REAR AXLE
BRAKE
FRONT AXLE
STEERING
HYDRAULIC
ELECTRIC
INDEX
Check point Check item (method) Remarks
1. Battery voltage - Measure the voltage between
battery (+) and (-) terminals us-
ing a tester.
- Result: 11.8 ~ 12.9 V
However, the voltage may be over
this range if it is measured imme-
diately after turning the engine off.
2. Battery terminal of start
motor
- Proper connection of battery
cable
- The voltage between M termi-
nal of start motor and chassis
should be approximately same
to the battery voltage.
- Check for corrosion.
- Check connection of battery
cable.
3. Slow blow fuse - Check fuse engagement.
- Check main fuse for short circuit.
Rated capacity: 60 A
4. Key switch Check for proper connection.
“OFF” position: No connection
“ACC” position: A-B
“ON” position: A-B-D
"PREHEAT" position: A-C-D
"ST" position: A-D-E
A - Battery
B - Accessory
C - Engine heat
D - Key s/w on
E - Start
5. Ignition relay, engine
stop pull coil relay
1. Connecting the power to No. 85
and 86 terminals: No. 87 and 30
terminals connected
2. Not connecting the power to No.
85 and 86 terminals : No. 87 and
30 terminals open
T46WBB9A
T46WBC0A
H61WB33A
T46WBC2A
H61WB34B
7.2.1 WHEN THE ENGINE CANNOT BE STARTED
7.2 TROUBLESHOOTING
ELECTRIC SYSTEM - DIAGNOSIS AND TROUBLESHOOTING
UTV(EZGO향)_12_ELECTRIC SYSTEM.in섹션1:55 섹션1:55 UTV(EZGO향)_12_ELECTRIC SYSTEM.in섹션1:55 섹션1:55 2011-04-04 오후 4:36:57 2011-04-04 오후 4:36:57