Ezgo 1600xd, Repair Manual

Page: 200 / 416

6
-12
SUUV-W00 Apr. 2011
SAFETY
FIRST
GENERAL
ENGINE
CVT
TRANSMISSION
CHASSIS
REAR AXLE
BRAKE
FRONT AXLE
STEERING
HYDRAULIC
ELECTRIC
INDEX
UUVW563A
Unscrew the speed control lever bracket adjust-
ing nut (1) on the engine side and disconnect the
cable. 3.
CHASSIS - DISASSEMBLY, SERVICE AND ASSEMBLY
UUVW566A
To adjust the cable length, lower the accelerator
lever to the lowest position of the guide and fi t its
cable end on the engine side to the speed control
lever groove. Then, install the cable to the speed
control lever bracket, pulling it gently with the
speed control lever not pulled up, and tighten the
adjusting nut to secure it.
•
IMPORTANT
Unscrew the accelerator lever mounting double
nut and remove the nut (1), plain washer (2), plate
spring (3), bracket (4), brake lining (5) and accel-
erator lever (6).
Assemble in reverse order of disassembly.
5.
6.
UUVW565A
Pull out the cable mounting snap pin (1) on the ac-
celerator lever side and unscrew the cable adjust-
ing nut (2) from the bracket to disconnect the cable. 4.
UUVW564A
When installing the accelerator lever to the bracket,
make sure to install the plate springs facing each
other (convex side outward) and tighten the double
nut to secure them. 7.
UTV(EZGO향)_06_CHASSIS.indd 12 UTV(EZGO향)_06_CHASSIS.indd 12 2011-04-04 오후 3:52:02 2011-04-04 오후 3:52:02