4
-9
SUUV-W00
Apr. 2011
SAFETY
FIRST
GENERAL
ENGINE
CVT
TRANSMISSION
CHASSIS
REAR AXLE
BRAKE
FRONT AXLE
STEERING
HYDRAULIC
ELECTRIC
INDEX
4. INSPECTION AND ADJUSTMENT
4.1 ADJUSTING DISTANCE BETWEEN SHAFTS FOR PULLEYS
Shafts & offset measuring jig (without adapter
attached)
•
UUVW243A
REMARK
7514#
65:148
495
54
3
0#314
##0#3138
0#314
ᴉ3135#
ᴉ3135
UUVW303A
Part number : UCVT-P00
mm.
When the distance between the shafts and offset val-
ues are uncertain during the inspection of the CVT or
installation of the engine or gear box, perform the fol-
lowing procedures to measure the distance between
shafts and offset value for the engine fl ywheel and gear
box input shaft.
Fit the shaft alignment setting jig to the gear box
input shaft and the engine fl ywheel.
1.
UUVW477A
Measure the gap between jig and the step on the
gear box input shaft as shown in the picture. The
gap should be in
±
1mm (0.03937 in.).
If everything is OK, tighten the mounting bolts for
engine of gear box as needed.
For detailed information about adjustment, refer to
"5.2 CVT Assembly."
2.
3.
4.
ᴉ4
UUVW304A
CVT - INSPECTION AND ADJUSTMENT
UTV(EZGO향)_04_CVT.indd 9
UTV(EZGO향)_04_CVT.indd 9
2011-04-04 오후 3:45:40
2011-04-04 오후 3:45:40
Summary of Contents for 1600xd
