Ezgo 1600xd, Repair Manual

Page: 155 / 416

4
-17
SUUV-W00 Apr. 2011
SAFETY
FIRST
GENERAL
ENGINE
CVT
TRANSMISSION
CHASSIS
REAR AXLE
BRAKE
FRONT AXLE
STEERING
HYDRAULIC
ELECTRIC
INDEX
CAUTION
Impeller cover mounting bolt
The shaft of fi xing pulley assembly and the
attaching area of spider assembly
Centrifugal lever lock nut
•
•
•
When reassembling the drive pulley assembly
(driving part CVT assembly), tighten the impel-
ler cover bolt to the diagonal direction gradu-
ally by turns.
Apply the adhesive equivalent LOCTITE #271
to the following screw thread.
1.
2.
After disassembling the lock nut of centrifugal
lever, you should replace it with new one to as-
semble. 3.
5.4 DRIVEN PULLEY ASSEMBLY COMPONENTS
DISASSEMBLY AND ASSEMBLY
UUVW352A
1. As the cam block (1) of the driven pulley is pressed
into the mounting fl ange, the driven pulley cannot
be disassembled. If its malfunction or damage is
found, the whole driven pulley assembly should be
replaced.
If the clutch button (2) is worn, replace it. Refer to
“How to change the clutch button” in section 4.2.
•
REMARK
UTV(EZGO향)_04_CVT.indd 17 UTV(EZGO향)_04_CVT.indd 17 2011-04-04 오후 3:46:09 2011-04-04 오후 3:46:09