Ezgo 1600xd, Repair Manual

Page: 373 / 416

12
-35
SUUV-W00 Apr. 2011
SAFETY
FIRST
GENERAL
ENGINE
CVT
TRANSMISSION
CHASSIS
REAR AXLE
BRAKE
FRONT AXLE
STEERING
HYDRAULIC
ELECTRIC
INDEX
5.16 FLASHER UNIT (OPTIONAL)
UUVWA30A
5.17 ENGINE STOP RELAY (5P)
UUVWA31A
The fl asher unit is attached to the relay bracket un-
der the hood. The engine stop relay is attached to the relay
bracket under the hood.
This relay is used as power supply to the pull coil of the
engine stop solenoid.
Flasher unit
Fuse
Lamp
DC12V
Hazard
warning
flasher
switch
Turn signal
lamp
switch
T46WB56A
TERMINAL IDENTIFICATION AND CIRCUIT
This shows terminals and circuit of the fl asher unit.
A 12-volt battery and auxiliary light are needed to test
the fl asher unit. Install the battery’s positive cable to the
terminal B of the fl asher unit. Install the light’s positive (+)
lead to the terminal L of the fl asher unit. Install the light’
s negative (-) lead to the battery's negative terminal. The
light will fl ash and the unit will make a clicking sound if
the unit is functioning properly.
Replace the flasher unit if the test result does not
match above.
FLASHER UNIT TEST
To perform the relay test, disconnect and remove the
relay from the wiring.
Check the resistance and continuity within the resis-
tance range (
Ω
) of a tester.
Numbers on the auxiliary relay terminals indicate cor-
responding coil and contact.
Capacity: 40A •
Terminal diagram
T46WB60A
T46WB61A
RELAY TEST
ELECTRIC SYSTEM - ELECTRICAL COMPONENTS
UTV(EZGO향)_12_ELECTRIC SYSTEM.in섹션1:35 섹션1:35 UTV(EZGO향)_12_ELECTRIC SYSTEM.in섹션1:35 섹션1:35 2011-04-04 오후 4:36:23 2011-04-04 오후 4:36:23