Endress+Hauser Proline Prowirl F 200, Operating Instructions Manual

Page: 135 / 224

Proline Prowirl F 200 PROFIBUS PA Operation
Hauser 135
Parameter overview with brief description
Parameter Prerequisite Description User interface
Terminal voltage 1 – Displays the current terminal voltage
that is applied at the output. 0.0 to 50.0 V
Pulse output The Pulse option is selected in the
Operating mode parameter parameter.
Displays the pulse frequency currently
output. Positive floating-point
number
Output frequency In the Operating mode parameter, the
Frequency option is selected.
Displays the value currently measured
for the frequency output. 0 to 1 250 Hz
Switch status The Switch option is selected in the
Operating mode parameter.
Displays the current switch output
status. • Open
• Closed
11.5 Adapting the measuring device to the process
conditions
The following are available for this purpose:
• Basic settings using the Setup menu (→  70)
• Advanced settings using the Advanced setup submenu (→  83)
11.6 Performing a totalizer reset
The totalizers are reset in the Operation submenu:
Control Totalizer
Function scope of the "Control Totalizer " parameter
Options Description
Totalize The totalizer is started.
Reset + hold The totaling process is stopped and the totalizer is reset to 0.
hold The totaling process is stopped and the totalizer is set to its defined start value
from the
Preset value 1 to n parameter.
Stop totalizing option Totalizing is stopped.
Navigation
"Operation" menu → Totalizer handling
‣
Totalizer handling
Control Totalizer 1 to n
→  136
Preset value 1 to n →  136