Endress+Hauser Proline Prowirl F 200, Operating Instructions Manual

Page: 104 / 224

Commissioning Proline Prowirl F 200 PROFIBUS PA
104 Hauser
Parameter overview with brief description
Parameter Prerequisite Description Selection / User
entry
Factory setting
Assign pulse output The Pulse option is selected in
the Operating mode
parameter.
Select process variable for
pulse output. • Off
• Volume flow
• Corrected volume
flow
• Mass flow
• Total mass flow
*
• Energy flow
*
• Heat flow
difference
*
Volume flow
Value per pulse In the Operating mode
parameter, the Pulse option is
selected, and one of the
following options is selected in
the
Assign pulse output
parameter (→  104):
• Volume flow
• Corrected volume flow
• Mass flow
• Total mass flow
*
• Energy flow
*
• Heat flow difference
*
Enter measured value at which
a pulse is output. Positive floating-
point number Depends on country
and nominal
diameter
Pulse width In the Operating mode
parameter, the Pulse option is
selected, and one of the
following options is selected in
the
Assign pulse output
parameter (→  104):
• Volume flow
• Corrected volume flow
• Mass flow
• Total mass flow
*
• Energy flow
*
• Heat flow difference
*
Define time width of the
output pulse. 5 to 2 000 ms 100 ms
Failure mode In the Operating mode
parameter, the Pulse option is
selected, and one of the
following options is selected in
the
Assign pulse output
parameter (→  104):
• Volume flow
• Corrected volume flow
• Mass flow
• Total mass flow
*
• Energy flow
*
• Heat flow difference
*
Define output behavior in
alarm condition. • Actual value
• No pulses No pulses
Invert output signal – Invert the output signal. • No
• Yes No
* Visibility depends on order options or device settings
Configuring the frequency output
Navigation
"Setup" menu → Pulse/frequency/switch output
Pulse/frequency/switch output
Assign frequency output →  105