Endress+Hauser Proline Prowirl F 200, Operating Instructions Manual

Page: 134 / 224

Operation Proline Prowirl F 200 PROFIBUS PA
134 Hauser
Totalizer status 1 to n →  134
Totalizer status (Hex) 1 to n →  134
Parameter overview with brief description
Parameter Prerequisite Description Selection / User
entry / User
interface
Factory setting
Assign process variable – Select process variable for
totalizer. • Volume flow
• Mass flow
• Corrected volume
flow
• Total mass flow
*
• Condensate mass
flow
*
• Energy flow
*
• Heat flow
difference
*
• Totalizer 1:
Volume flow
• Totalizer 2: Mass
flow
• Totalizer 3:
Corrected volume
flow
Totalizer value 1 to n In the Assign process variable
parameter one of the following
options is selected:
• Volume flow
• Mass flow
• Corrected volume flow
• Total mass flow
• Condensate mass flow
• Energy flow
• Heat flow difference
Displays the current totalizer
counter value. Signed floating-point
number 0 m³
Totalizer status 1 to n – Displays the current totalizer
status. • Good
• Uncertain
• Bad –
Totalizer status (Hex) 1 to n In Target mode parameter,
the Auto option is selected.
Displays the current status
value (hex) of the totalizer. 0 to 0xFF –
* Visibility depends on order options or device settings
11.4.3 Output values
The Output values submenu contains all the parameters needed to display the current
measured values for every output.
Navigation
"Diagnostics" menu → Measured values → Output values
‣
Output values
Terminal voltage 1 →  135
Pulse output →  135
Output frequency
→  135
Switch status →  135