Endress+Hauser Proline Prowirl F 200, Operating Instructions Manual

Page: 107 / 224

Proline Prowirl F 200 PROFIBUS PA Commissioning
Hauser 107
Parameter Prerequisite Description Selection / User
entry
Factory setting
Failure mode In the Operating mode
parameter (→  103), the
Frequency option is selected,
and one of the following
options is selected in the
Assign frequency output
parameter (→  105):
• Volume flow
• Corrected volume flow
• Mass flow
• Flow velocity
• Temperature
• Pressure
• Calculated saturated steam
pressure
*
• Steam quality
*
• Total mass flow
*
• Energy flow
*
• Heat flow difference
*
Define output behavior in
alarm condition. • Actual value
• Defined value
• 0 Hz 0 Hz
Failure frequency In the Operating mode
parameter (→  103), the
Frequency option is selected,
and one of the following
options is selected in the
Assign frequency output
parameter (→  105):
• Volume flow
• Corrected volume flow
• Mass flow
• Flow velocity
• Temperature
• Pressure
• Calculated saturated steam
pressure
*
• Steam quality
*
• Total mass flow
*
• Energy flow
*
• Heat flow difference
*
Enter frequency output value
in alarm condition. 0.0 to 1 250.0 Hz 0.0 Hz
Invert output signal – Invert the output signal. • No
• Yes No
* Visibility depends on order options or device settings
Configuring the switch output
Navigation
"Setup" menu → Pulse/frequency/switch output
Pulse/frequency/switch output
Switch output function →  108
Assign diagnostic behavior
→  108
Assign limit →  108
Assign flow direction check →  108