60
Elmark Automatyka S.A.
ul. Niemcewicza 76, 05-075 Warszawa, tel. (+48) 22 773 79 37; [email protected]; www.elmark.com.pl
NIP: 5252072585; KRS: 0000803828, Sąd Rejonowy dla M-St. Warszawy, XIV Wydział Gosp. KRS; Kapitał Zakładowy 525.000 zł, w pełni opłacony
Figure 4-16 Diagram when the jump frequency is valid during the process of acceleration/deceleration
P8.25
Frequency switchover point between acceleration time1 and
acceleration time 2
Default
0.00Hz
Setting Range
0.00Hz ~ maximum frequency
P8.26
Frequency switchover point between deceleration time 1
and deceleration time 2
Default
0.00Hz
Setting Range
0.00Hz ~ maximum frequency
This function is valid when the motor selects acceleration/ deceleration time that is not performed by means of S terminal's
switchover. It is used to select different groups of acceleration/ deceleration time based on the running frequency range rather
than S terminal during the running process of the AC drive.
During the process of acceleration, if the running frequency is smaller than the value of PB.25, acceleration lime 2 is selected. If
the running frequency is larger than the value of PB.25, acceleration time 1 is selected.
During the process of deceleration, if the running frequency is larger than the value of P8.26, deceleration time 1 is selected. If
the running frequency is smaller than the value of P8.26, deceleration time 2 is selected.
P8.27
Terminal JOG preferred
Default
0
Setting Range
0: Disabled
1: Enabled
It is used to set whether terminal JOG is the highest priority.
If terminal JOG is preferred, the AC drive switches to terminal JOG running state when there is a terminal JOG command during
the running process of the AC drive.
P8.28
Frequency detection value (FDT2)
Default
50.00Hz
Selling Range
0.00Hz ~ maximum frequency
Summary of Contents for elmatic ED2000
Page 1: ......
