Delta ASD-A3-0121, User Manual

Page: 295 / 603

Parameters ASDA-A3
8-38
Revision December, 2017
8
P1.019 Capture / Compare additional function settings
Address: 0126H
0127H
Default: 0x0000 Control mode: ALL
Unit: - Setting range: 0x0000 – 0x0101
Format: HEX Data size: 16-bit
Settings:
Y U X Z
X Additional function for Capture Z Additional function for Compare
Y Reserved U Reserved

X: additional function for Capture
3 2 1 0
Bit
Bit Function Description
0
Cycle
mode
Set this bit to 0 to disable this function.
Set this bit to 1 to enable this function.
If enabled, the E-Cam alignment correction is conducted when
DI.ALGN is on.
1 – 3 Reserved -

Z: additional function for Compare
3 2 1 0
Bit
Bit Function Description
0
P1.024 is
reset to 0
automatically
Set this bit to 0 to disable this function.
Set this bit to 1, and P1.024 is reset to 0 automatically,
but it only takes effect once.
1 – 3 Reserved -
P1.020 Capture - Masking range
Address: 0128H
0129H
Default: 0 Control mode: ALL
Unit: Pulse unit of capture source Setting range: 0 – 100000000
Format: DEC Data size: 32-bit
Settings:
When the Capture function is enabled and set to capture multiple points (P5.038 > 1), the system stops
receiving the DI captured signal within this range once the data is captured. The DI captured signal
received within this range is not recognized as valid. Use this function to avoid the system seeing noise
as effective signals within the non-capture range. The masking range is defined as follows: (CAP_DATA
– P1.020, CA P1.020).