44.
Setup printing Transparency from Multipurpose Feeder
On the printer operator panel press
MENU
.
1.
Press
to get to
Tray Settings
.
2.
Press
to select
Tray Settings
.
3.
Press
to get to
Paper Size
. (ONLY ON 3x00cn)
4.
Press
to select
Paper Size
. (ONLY ON 3x00cn)
5.
Press
to get to
MPF
. (ONLY ON 3x00cn)
6.
Press
to select
MPF
. (ONLY ON 3x00cn)
7.
Using
and
, select the appropriate paper size (Transparency). (ONLY ON 3x00cn)
8.
Press the middle button,
SELECT
, once Transparency is displayed on the lower line, this puts a * by it.
(ONLY ON 3x00cn)
9.
Now we have the MPF Size set to Transparency. (ONLY ON 3x00cn)
10.
Now press
MENU
to get back to
Tray Settings/Paper Size
.
11.
Press
to get to
Paper Type
.
12.
Press
to select
Paper Type
.
13.
Press
to get to
MPF
.
14.
Press
to select
MPF
.
15.
Using
and
, select the appropriate paper type (Transparency).
16.
Press
SELECT
, once Transparency is displayed on the lower line.
17.
Now we have the MPF Type set to Transparency.
18.
Now press
MENU
to get back to
Ready to Print
19.
Now insert the Transparency-sized stack of paper into the MPF.
20.
On the screen
MPF/Transparency
will appear. (ONLY ON 3x00cn)
21.
Press
SELECT
to confirm this. (ONLY ON 3x00cn)
22.
Now on the screen
MPF/Transparency
will appear.
23.
Press
SELECT
to confirm this.
24.
We now have all the hardware settings on the printer correct
25.
Now, all software settings screen shots are from WORD, this was done in Word 2003. However if in any
26.
Summary of Contents for 3110 Color Laser
