Dell 3110 Color Laser, User Manual

Page: 228 / 451

Load the recommended print side correctly for the type of print media
you are using. See "
Loading Print Media in Standard and Optional Trays "
for more information.
Turn the print media over or around and try printing again to see if
feeding improves.
Do not mix print media types.
Do not mix reams of print media.
Remove the top and bottom sheets of a ream before loading the print
media.
Load a print media source only when it is empty.
Wipe the feeder rollers in the trays or multipurpose feeder with a cloth
that slightly dampened with water.
Envelope misfeeds or multiple
feeds occur. Reduce the number of envelopes in the stack.
Page breaks in unexpected
places. Check the Time-Out in the
System Settings
menu. Increase the setting.
Job prints from the wrong
source or on the wrong print
media. Check the Paper Type in the
Tray Settings
menu on the printer
operator panel and in the printer driver.
Print media does not stack
neatly in the output bin. Turn the print media stack over in the tray or multipurpose feeder.
Printer does not duplex pages. Make sure
2 Sided
is selected in both the
PCL (
Printer Control
Language
)
menu on the printer operator panel and in the printer driver.
Make sure you have enough print memory installed.
Print Quality Problems
Problem
Action
Print is too light.
· The print cartridges may be low or need to be replaced. Confirm the amount
of toner in each print cartridge and replace it with a new one if necessary.
· Set the Toner Saving Mode check box to off in the Advanced tab in the
printer driver.
· If you are printing on an uneven print surface, change the
Paper Type
settings in the
Tray Settings
menu. See " System Settings ."
· Verify that the correct print media is being used.