Supplemental Guide – DOC. 8412A
UC-P100-S/UC-P110-S Phones for Skype for Business
•
3
NOTE:
The word “None” in the Web User Interface or Phone User Interface field means
the feature cannot be configured via web/phone user interface.
Method 1: Central Provisioning
This table specifies the details of account.1.auto_answer parameter, which enables or
disables the auto answer feature. This parameter is disabled by default. To enable the
auto answer feature, open the MAC.cfg file and locate the parameter name
account.1.auto_answer. Set the parameter value to “1” to enable the auto answer
feature or “0” to disable the auto answer feature.
Note that some parameters described in this guide contain one or more variables (e.g., X
or Y), however, the variables in the parameters described in the CFG file are all replaced
with a specific value in the scope of variable. A value may need to be assigned to the
variable before searching and locating the specific parameter in the CFG file.
For example, to configure the dial-now rule, locate the parameter dialplan.dialnow.rule.X
in the Common.cfg file and then configure as required (e.g., dialplan.dialnow.rule.1 = 123).
Parameter name
Feature explanation
Parameter value definition
Important information
Web path
Phone path
Permitted parameter value
Default value
PARAMETER
PERMITTED VALUES
DEFAULT
Configures the Internet (WAN) port type for IPv4.
0-
DHCP
2-
Static IP Address
It works only if the value of the parameter “static.network.ip_address_mode” is set to 0
(IPv4) or 2 (IPv4 & IPv6). If the parameter is changed, the phone will reboot to make the change
take effect.
Network > Basic > IPv4 Config
Menu > Setting > Advanced (default password: admin) > Network > WAN Port > IPv4
