Cmsemicon BAT32G1 9 Series, User Manual, Page: 356 / 1149

BAT32G1x9 user manual | Chapter 10 Timer M
www.mcu.com.cn
356 / 1149 Rev.1.02
Fig. 10-35 Timer M General Purpose registers Ai, Bi, Ci, Di
Format of (TMGRAi, TMGRBi, TMGRCi, TMGRDi) (i=0, 1) [ Output comparison function].
Address: 0x40042A78 (TMGRA0), 0x40042A7A (TMGRB0), After Reset: FFFFH R/W
0x40042B58 (TMGRC0) , 0x40042B5A (TMGRD0) ,
0x40042A88 (TMGRA1) , 0x40042A8A (TMGRB1) ,
0x40042B5C(TMGRC1), 0x40042B5E(TMGRD1)
Symbol 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
TMGRAi
TMGRBi
TMGRCi
TMGRDi
—
function
bit15
～
0
Refer to "Table 10-4 TMGRji Register Function When Using the Output Comparison
Function".
Table 10-4 The TMGRji register function when using the output comparison function
register
Set up
Register function
Output pin for output
comparison
TMBFki IOj3
TMGRAi
— —
A general purpose register that must write the comparison
value.
TMIOAi
TMGRBi TMIOBi
TMGRCi
0 1
A general purpose register that must write the comparison
value.
TMIOCi
TMGRDi TMIODi
TMGRCi
1 1
Buffer registers, which must write down the next comparison
value
(See "10.4.2 Buffer Run").
TMIOAi
TMGRDi TMIOBi
TMGRCi
0 0
TMIOAi output
control
(Refer to "Changes to the Output Pins
of the 10.5.2(2)TMGRCi Register and
the TMGRDi Register (i=0, 1)").
TMIOAi
TMGRDi
TMIOBi output
control
TMIOBi
Note if you put the TCK2~TCK0 position
of
the TMCRi register "000B" (f
CLK
, f
HOCO
And set the comparison value
to "0000H"
to
generate a
request signal to the
DMA and ELC only after starting the count. If the comparison
value is greater than or equal to "0001H", a request signal is generated at each time the comparison matches.
Remark i=0, 1,j=A, B, C, D,k=C, D
TMBFki:
Bits of
TMMR registers, IOj3: Bits of TMIORCi
registers