BAT32G1x9 user manual | Chapter 10 Timer M
416 / 1149
Rev.1.02
10.8.3
Operation of PWMOP
The output of comparator 0, the INTP0 input, and the event input of EVENTC can be selected as output
force cutoff sources.
When selecting the output of comparator 0 and the input of INTP0 as the source, you can select the edge
checkout.
10.8.3.1
Output forces cutoff
The output of comparator 0, the INTP0 input, and the event input of EVENTC can be selected as trigger
events to force the cutoff TMIOji(j=A, B, C, D; i=0,1) of the output.
When a trigger event is detected, the output of timer M is forced to cut off and thesetting value of register O
PDF0/OPDF1 is output. For detailed actions, see Figure 10-7 5.
The H S_SELbit of theOPCTL0 registers allows you to choose to remove the forced cutoff function by
software or hardware.
10.8.3.2
Hardware release (HS_SEL=0).
When timer M works in different modes, the de-timing is different:
（
1
）
Outputs outside of complementary PWM functions
⚫
When timer M operates in output comparison function, PWM
function, or PWM3
mode, after the
desermission event occurs, when
the count value of TM0 is 0000H, the forced cut-off of TMIOj0
(j=A, B, C, D) is lifted.
When
the count value of TM0 is 0000H, the forced cutoff of TMIOj1 (j=A,
B, C, D) is lifted.
⚫
When timer M is operating in reset PWM
mode during the same period
, after the de-event occurs, when
the count value of TM0 is 0000H, the forced cutoff of all T MIO pins is completely released.
