Cmsemicon BAT32G1 9 Series, User Manual

Page: 1063 / 1149

BAT32G1x9 user manual | Chapter 26 Interrupt function
www.mcu.com.cn
1063 / 1149 Rev.1.02
Table 26-3 corresponds to the interrupt request signals for EGPn bits and EGNn bits
Detect the enable
bits Interrupt
request signal 100 pins 80 pins 64 pins 48 pins
EGP0 EGN0 INTP0
○ ○ ○ ○
EGP1 EGN1 INTP1
○ ○ ○ ○
EGP2 EGN2 INTP2
○ ○ ○ ○
EGP3 EGN3 INTP3
○ ○ ○ ○
EGP4 EGN4 INTP4
○ ○ ○ ○
EGP5 EGN5 INTP5
○ ○ ○ ○
EGP6 EGN6 INTP6
○ ○ ○ ○
EGP7 EGN7 INTP7
○ ○ ○
—
EGP8 EGN8 INTP8
○ ○ ○ ○
EGP9 EGN9 INTP9
○ ○ ○ ○
EGP10 EGN10 INTP10
○ ○ ○ ○
EGP11 EGN11 INTP11
○ ○ ○ ○
NoteIf you switch the input port used by the external interrupt function to output mode, an INTPn interrupt may be
detected and an INTPn interrupt may be detected. When switching to output mode,
the
port mode register
(
PMxx)
must be set to "
0
" after disabling the detection edge (
EGPn, EGNn=
0,
0).
Note 1 For ports for edge detection, refer to "2.1 Port Capabilities".
2.n=0
～
11