Rack-mounting a Single Unit
Lynx DSA User's Manual - 9240227J
203
Rack-mounting a Single Unit
This assembly must be done with power off, and preferably with no cables connected
to the Lynx unit(s). It is best to pre-assemble these parts on a bench, and install the
joined items as a unit into your equipment rack.
Remove the contents of the Rack Mount kit from its packing material.
Notes:
You will also need an Allen Wrench (4 mm or 5/32") and a #2 Phillips
screwdriver. You will also use mounting hardware from your rack system to
mount the joined components into your rack.
Using two of the provided socket-head cap screws (SHCS), connect the filler
piece to the side of the Lynx main unit. It is not necessary to 'open up' the
Lynx main unit. Then, add the brackets to make a complete 2U assembly.
CAUTION
:
If opening the Lynx case (required only if rack mounting
two Lynx units) you must exercise care to prevent
electro-static discharge into the unit.
Figure below shows one possible orientation of the components.
Figure 109: Rack Mounting a Single Lynx, Showing the Half-rack Filler Piece
