Rack-mounting Two Units
Lynx DSA User's Manual - 9240227J
205
Figure 110: Rack Mounting Two Lynx Units
Remove the Phillips-head screws from the top plate of one Lynx unit (this will
become the right-side unit), and remove the cover and set it aside.
CAUTION
:
Before approaching the open Lynx unit, touch the
outside of its metal case to discharge any electro-static
energy, and maintain contact with the metal case while
working inside the unit. Be careful to not contact any
circuit boards or components inside the Lynx unit with
your Allen wrench.
Using two of the provided socket-head cap screws (SHCS), you will join the right
Lynx to the left Lynx (as facing them from their front sides).
•
From inside the right Lynx unit, and using two SHCS in the two upper screw
holes (just above the circuit boards), insert and tighten the screws until snug
with your Allen wrench. Do not over-tighten the screws.
•
You will use two provided flat-head Phillips screws, provided in the kit, to
attach each of the rack bracket/handles to the side of the joined units.
Position the handles to the forward-most holes on the side of the Lynx units.
