AMX TPI-PRO-4, Operation/Reference Manual

Page: 27 / 218

Wiring and Device Connections
13 TPI-PRO (Total Presentation Interface)
SOURCE KEYBOARD/MOUSE (USB-Type B) Device Ports 1-4
The USB (Type B) Device ports on the rear panel (labelled "SOURCE KEYBOARD/MOUSE") are used to
connect up to four source PCs to the TPI-PRO to provide pass-through control for the connected PCs
(FIG. 11).

The TPI-PRO-2 has two USB-Type B Device Ports (corresponding with VIDEO/VGA Inputs 1-2)

The TPI-PRO-4 has four USB-Type B Device Ports (corresponding with VIDEO/VGA Inputs 1-4)
These numbered USB Device ports correspond to the numbered VIDEO/VGA Inputs:
1.
The PC connected to USB Device port #1 has pass-through control of the input device connected to
VIDEO/VGA Input #1.
2.
The PC connected to USB Device port #2 has pass-through control of the input device connected to
VIDEO/VGA Input #2.
3.
The PC connected to USB Device port #3 has pass-through control of the input device connected to
VIDEO/VGA Input #3 (
TPI-PRO-4 only ).
VGA OUT HD-15 Connector Pinouts
Pin Signal Function
1 Red Red signals
2 Green Green signals
3 Blue Blue signals
4 N/C Monitor ID bit 2
5 GND Signal Ground
6 RAGND Red analog ground
7 GAGND Green analog ground
8 BAGND Blue analog ground
9 +5VDC Not used
10 SAGND Synchronization analog ground
11 N/A Monitor ID bit 0
12 DDC_SDA Monitor ID bit 1
13 HSYNC Horizontal synchronization signal
14 VSYNC Vertical synchronization signal
15 DDC_SDL Monitor ID bit 3
FIG. 11 SOURCE KEYBOARD/MOUSE (USB-Type B) Device Ports
VGA HD-15 (male)
10
6
5
1
15
11
USB (Type B) Device Port 1
USB (Type B) Device Port 2
USB (Type B) Device Port 3
USB (Type B) Device Port 4
The TPI-PRO requires that the host PC uses USB v2.0.