ABX Pentra 80 RAB108EA, User Manual

Page: 96 / 306

Pentra 80
4–4
Pentra 80 - User Manual - RAB108EA
1.2. Workflow
Once the
ABX PENTRA 80
has started the analysis process on a sample tube, an order is gen-
erated to search the worklist for 2 of the following criteria:
◆ The Rack position number where the tube has been placed:
◆ The barcode Sample ID
The order-searching mode is generated based on specific settings that were select-
ed by the operator Section 5,
2.2. General tab , page 5-6.
When the associated order is found, the instrument will automatically perform the required
analysis that was generated from the information in the worklist, such as defined blood type
and the patient demographics that are associated with each sample.
1.3. Worklist
Worklist orders allow the following criteria:
◆
a single identification of a sample tube
◆ selection of the test to be performed (CBC or DIFF).
◆ Selection parameter ranges according to the specific blood types, (i. e. Male, Female,
Child, etc…)
◆ the creation of a patient file and patient demographics
◆ Matching orders to specific patient files
When creating orders, there are only 2 modes available:
1- A graphics screen (see 2.4. Rack view, page 4-20) that simulates a rack view with
sample tube positions. This mode must be used with the following Setting : « Rack /
Position » Section 5, 2.2.5. Identification option , page 5-7.
2- A grid that is intended to identify the sample tube by means of Barcode labeling.
Entering the sample tube position in the rack is not available while in this mode. This
mode must only be used with the following setting, «
Barcode » Section 5,
2.2.5. Identification option , page 5-7.
The worklist sample management depends on laboratory organization. This must be
defined when the instrument is installed (barcode or rack/position).