PANNORAMIC® CONFOCAL RX 1.0
INSTALLATION
MAY 13, 2021
25
FOR RESEARCH USE ONLY. NOT FOR USE IN DIAGNOSTIC PROCEDURES .
•
Power supply cable (between 230V/110V and control computer)
•
Power supply cable (between 230V/110V and the power inlet of the Pannoramic®
Confocal RX)
•
USB cable (between preview camera and control computer)
•
USB control cable (between the USB control port at the connector panel of the
scanner and control computer)
•
USB cable for Aurox CC88 Confocal RX unit (between Pannoramic® Confocal RX
and control computer)
•
USB-to-RS232 serial communication cable (between Pannoramic® Confocal RX
and control computer for Lumencor fluorescent illumination unit)
•
CameraLink cables (between pco.edge 5.5 camera and control computer)
•
Video cable (between monitor and control computer)
Warning!
Only connect external devices that are safety extra low voltage rated to the instrument to
avoid the risk of electrical shock.
2.4
Power the scanner on/off
The main power switch is a rocker switch (see
Figure 3
–
part
3
in
)
that is located at the bottom right corner of the back side of the scanner. To turn the scanner on,
press down the
I
side of the rocker switch, and press the
O
side down to turn the scanner off.
