Remote Control Commands
R&S
®
SMBV100B
609
User Manual 1178.4460.02 ─ 03
12
Remote Control Commands
In the following, all remote-control commands are presented in detail with their param-
eters and the ranges of numerical values.
For an introduction to remote control and the status registers, refer to:
●
Chapter 11, "Network Operation and Remote Control"
●
Chapter A.1, "Additional Basics on Remote Control"
12.1
Conventions used in SCPI Command Descriptions
Note the following conventions used in the remote command descriptions:
●
Command usage
If not specified otherwise, commands can be used both for setting and for querying
parameters.
If a command can be used for setting or querying only, or if it initiates an event, the
usage is stated explicitly.
●
Parameter usage
If not specified otherwise, a parameter can be used to set a value and it is the
result of a query.
Parameters required only for setting are indicated as
Setting parameters
.
Parameters required only to refine a query are indicated as
Query parameters
.
Parameters that are only returned as the result of a query are indicated as
Return
values
.
●
Conformity
Commands that are taken from the SCPI standard are indicated as
SCPI con-
firmed
. All commands used by the R&S
SMBV100B follow the SCPI syntax rules.
●
Asynchronous commands
A command which does not automatically finish executing before the next com-
mand starts executing (overlapping command) is indicated as an
Asynchronous
command
.
●
Reset values (*RST)
Default parameter values that are used directly after resetting the instrument (
*RST
command) are indicated as
*RST
values, if available.
●
Factory preset values
Default parameter values that are reset only by factory preset.
●
Default unit
The default unit is used for numeric values if no other unit is provided with the
parameter.
●
Manual operation
If the result of a remote command can also be achieved in manual operation, a link
to the description is inserted.
Conventions used in SCPI Command Descriptions
