Rohde & Schwarz SMBV100B, Руководство пользователя

Страница: 328 / 1030

Configuring the RF Signal
R&S
®
SMBV100B
326 User Manual 1178.4460.02 ─ 03
Live list processing mode
The R&S SMBV100B generates the signal directly from the value pairs in the data-
base, and adjusts the hardware settings accordingly. The current instrument state and
thus any change during the signal generation directly affects the RF signal. The tempo-
rary memory is not used.
You can conveniently modify parameters like modulation settings during run-time.
Learning list mode data is not required. Impacts like temperature drift are also consid-
ered immediately.
This mode is optimized for maximum signal quality , and is useful if dwell times higher
than 2 ms are sufficient.
6.10.5 Sweep Mode Settings
This section lists the settings of all available sweep modes.
Access:
1. Select "RF" > "Sweep/List" > "RF Frequency Sweep"
2. Select "RF" > "Sweep/List" > "RF Level Sweep"
3. Select "RF" > "Sweep/List" > "LF Frequency Sweep"
The sweep modes use the similar parameters to be configured. Thus, the descrip-
tion comprises the settings of the three dialogs, "RF Frequency Sweep", "RF Level
Sweep" and "LF Frequency Sweep". If parameters relate to only particular modes,
they are pointed out.
The remote commands required to define these settings are described in:
●
Chapter 12.16.6, "SOURce:FREQuency Subsystem" , on page 820
●
Chapter 12.16.17, "SOURce:SWEep Subsystem" , on page 881
●
Chapter 12.16.10, "SOURce:LFOutput Subsystem" , on page 837
Settings
● General Sweep Settings ....................................................................................... 326
● Frequency Range Settings ....................................................................................331
● Level Range Settings ............................................................................................333
6.10.5.1 General Sweep Settings
Access:
► Select, for example, "RF" > "Sweep/List" > "RF Frequency Sweep".
Varying the RF Signal in List or Sweep Mode