Pitney Bowes Relay 5000, Руководство оператора, Страница: 63 / 202

SV63136 Rev. A
3-19
Basic Operation • 3
The envelope openers in the insertion area open each envelope to allow
insertion of the contents. If you are using a different size envelope than the
previous job, you need to confirm that the envelope aligns properly with
the Openers before running the new job. If the alignment is incorrect, you
need to adjust the position of the envelope openers. Follow the steps in the
section below to verify envelope alignment and to make adjustments.
Feed a Test Envelope
1. Load the outer envelopes into the envelope feeder(s).
2. Select
Loading Instructions from the Home screen, and then select
Pre-Run Adjustments , and finally select Envelope Opener Settings .
NOTE: The system will automatically select the feeder when only one outer
envelope is being used. If multiple outer envelopes are to be used, you need
to select an envelope Feeder.
3. Press TRIAL PIECE to feed one envelope to the insertion area.
4. Open the insertion area cover and observe the envelope. If you need
to make adjustments, follow the procedures for setting the width and/or
length, as stated next.
Making Pre-Run
Adjustments
Once you have loaded the items for the selected job, you may need to make
some envelope opener adjustments to ensure job accuracy.
Adjusting
the Envelope
Openers
Figure 3.9.1: Insertion Area Cover
Open the Insertion
Area Cover