System Functions
Figure 10.13: The Min power dialog, sector is OFF
10.4
Hold Area
The function provides holding the vessel position in a presist area. If the function is available, the Parameters window
contains the corresponding tab named Hold Area (see figure 10.14), where the following parameters are available:
Fore-Aft speed
Athwartships speed
Hold Area gain
— gain of Hold Area controller;
Hold Area Radius
— the maximum area radius;
Warning Radius
— (% of the Hold Area Radius) — an alarm is generated in case the vessel approach to this radius;
Stop Radius
— (% of the Hold Area Radius) — the radius of the area where the vessel stops.
The absolute units are the global parameter that set in the Units tab.
The function runs by the
Hold Area
softkey pressing. After the softkey’s been pressed the setting dialog appears (see
figure 10.15).
When the Hold Area function is on the Map view displays two circles specifying Hold area (yellow solid) and Warning
Radius (yellow dashed).
This function is optional.
Doc. 000.JDP-10000-OME, rev.3.3.13/“2102.$–17A-Advanced”
178
Содержание NavDP 4000 Series
Страница 88: ...NAVIS NavDP 4000 Operation Manual Figure 5 35 Dark Theme 87 Doc 000 JDP 10000 OME rev 3 3 13 2102 17A Advanced...
Страница 222: ...NAVIS NavDP 4000 Operation Manual Figure 10 74 Drift Plot Window 221 Doc 000 JDP 10000 OME rev 3 3 13 2102 17A Advanced...
Страница 324: ...NAVIS NavDP 4000 Operation Manual Figure H 4 Remote DLS Mode 323 Doc 000 JDP 10000 OME rev 3 3 13 2102 17A Advanced...
