NAVIS NavDP 4000 Series, Руководство по эксплуатации

Страница: 162 / 348

NAVIS NavDP 4000. Operation Manual
tion. After NAVIS NavDP 4000 has recognized that the corresponding mode can be activated, the softkey becomes dark
green.
Case 5: softkey color — light red
The softkey is not activated. The light red color means that a fault has occurred while NAVIS NavDP 4000 was
operating in the corresponding control mode. After the NAVIS NavDP 4000 has recognized that the corresponding mode
can be activated, the softkey becomes dark green.
9.2 Heading Control Modes
9.2.1 Manual Heading (“Knob” mode)
To activate this mode, operator use the MAN softkey in the HDG panel.
The rotational moment demand is proportional to the rotary knob position, provided that the knob symbol remains
inside the grey area on the Thrust Ability Diagram.
Following options can be used in this mode:
– Auto Wind Compensation function (see Section 10.2, page 173)
– Remote COR position (COR in bow, stern, or other specified point)
The vessel motion in “Knob” mode is shown in Figure 9.1. This heading control mode can be combined with any
position control mode.
Figure 9.1: Manual Heading mode
9.2.2 ROT Heading Mode
To activate this mode, press the
ROT
softkey in the
HDG
panel.
Use the rotary knob for setting the rate of turn. The ROT demand is proportional to the value of the parameter ROT
specified in the HDG tab of the PARAM window.
The vessel motion in ROT Heading mode is shown in Figure 9.2.
Following options can be used in this mode:
– Remote COR position (COR in bow, stern, or other specified point);
– Heading Gain (gain of the heading controller).
This heading control mode can be combined with any position control mode.
161
Doc. 000.JDP-10000-OME, rev.3.3.13/“2102.$–17A-Advanced”