NAVIS NavDP 4000 Series, Руководство по эксплуатации

Страница: 323 / 348

Data Logging
yellow — warning — connection is ok, the data recording is processed but disk is close to overflow;
green — connection is ok, data recording is processed;
white — connection is ok but data recording process is stopped by the operator (only for “Remote” mode);
grey — the system contains DP (IJ) control station, but the station is not connected.
2.1. The record status is displayed in the entry field in the “BlackBox” mode (see figure H.2):
On — the data are recording (the permanent status);
Restart — the “Restart” softkey has been pressed.
The record is split into intervals. If “Continuous” mode is off, the interval is 1 hour.
NOTE! The interval size is the system setting and cannot be changed by opera-
tor.
Therefore a new interval can be started by operator command. To start the new interval:
– press “Restart” softkey. The value of the entry field will be changed to “Restart”;
– press “Apply” softkey to approve the command. Then DLS starts a new interval.
If you do not want to start the new interval, press either “Restart” softkey again or “Cancel” softkey to cancel
the command. Then DLS continues the current interval.
Restart operation affects all connected DL recorders (both DLS and local recorder).
NOTE! Restart operation is performed only on the selected host — DP (A and
B stations) / IJ.
2.2. The mode indication is displayed in the entry field in the “Remote” mode (see figure H.4):
On — the logging is on;
Off — the logging is off.
NOTE! The “Remote” mode is used in case the “BlackBox” option is not avail-
able (is not bought).
To change the mode (on — off):
– press “Change” softkey. The value of the entry field will be changed to “On” (“Off”);
– press “Apply” softkey to approve the command.
If you do not want to change the status, press either “Change” softkey again or “Cancel” softkey to cancel the
command.
The every mode switching forces the system to start a new record interval.
The selected mode (“On”/“Off”) persists after
NAVIS NavDP 4000
restarting.
H.2.1.2 Local Logging
The “Local” field contains a status of the local recorder.
There are two local recorder’s statuses:
On — local logging is on;
Off — local logging is off.
Doc. 000.JDP-10000-OME, rev.3.3.13/“2102.$–17A-Advanced”
322