NAVIS NavDP 4000 Series, Руководство по эксплуатации

Страница: 316 / 348

NAVIS NavDP 4000. Operation Manual
Figure G.18: DPShell. Choice feedbacks to delete
– Selected Feedback.
2.3.4 Select required item by rotary knob rotation and press “OK”. Wait for “Operation ‘Delete feedback’ completed
successfully” message will appear.
2.3.5 Press “Close” button.
2.4. Press “Done” button in “Feedback List” window (use arrow buttons for navigation).
G.2.8 DP/IJ Software Update
2.1. Unpack and install an Update Package to USB flash drive (follow individual package instructions).
2.2. Install Update Package from USB flash drive to all DP/IJ control computers for which this package is intended (see
Section G.2.9, page 315):
CC — for DP-0 class systems;
CC, IJ — for DP-1;
CCA, CCB, IJ — for DP-2.
2.3. Make sure that correct SW versions are installed on all DP/IJ control computers (see Warning note below).
To obtain information about NAVIS NavDP 4000 active version, follow steps as in Section G.2.10, page 316.
WARNING! For DP-2 class systems the same SW version should be installed
on both CCA and CCB control computers.
Never use
NAVIS NavDP 4000
in case of different versions are
active on DP/IJ control computers!
NOTE! SW versions installed on DP and IJ computers may vary.
2.4. NAVIS NavDP 4000 is ready to run with updated software.
G.2.9 Installing Update Package on Control Computer
All registered SW updates are logged in the
DPShell
utility (see Figure G.19). All necessary information about the
updates is available in “Update & Service” menu item, in the “Description” window.
2.1. Switch DP/IJ control computer into “Service Mode” (see Section G.2.2, page 311).
2.2. Insert USB flash drive with installed Update Package into DP/IJ control computer USB port. Wait for item “Un-
mount USB” will turn red.
2.3. Press “Update & Service” item in “Services” menu:
– wait for “Available updates List” window will appear (see Figure G.19). This operation may take up to several
minutes;
– select required Update Package (use rotary knob rotation for navigation).
2.4. Press “Execute” button (use arrow buttons for navigation):
– wait for a message “Operation Update DP-version with package ... completed successfully”;
– press “Close” button.
2.5. Update Package selected in 2.3 item is installed on control computer.
315
Doc. 000.JDP-10000-OME, rev.3.3.13/“2102.$–17A-Advanced”