NAVIS NavDP 4000. Operation Manual
Figure 10.82: Relationship between Wave Height and Wind Speed
NOTE!
Both wind speed and wave height are indicated in values set by the
operator in “Units” page of “Param” window.
NOTE!
Plot and cross time refresh is carried out not continually. The operator
should change value of any parameter (heading, wind, current direction,
etc.) and apply it, then the plot and data are being refreshed.
Selection of Hypothetic TAL Mode
To select a TAL mode:
– press
Change
softkey located under the TAL mode name;
– select a desired TAL mode in the opened dialog box (see Figure 10.83).
Figure 10.83: TAL Mode Selection Dialog Box
10.10
Consequence Analysis
The consequence analysis is performed to determine whether the vessel is able to maintain its position if a single or
group failure occurs.
Possible consequences are based on the actual environmental disturbances, enabled thrusters and power plant (gener-
ators, circuit breakers, tie breakers) status.
Typical worst-case single failures are:
– Thruster failure;
– Power component failure;
– Circuit breaker/tie breaker failure.
227
Doc. 000.JDP-10000-OME, rev.3.3.13/“2102.$–17A-Advanced”
Содержание NavDP 4000 Series
Страница 88: ...NAVIS NavDP 4000 Operation Manual Figure 5 35 Dark Theme 87 Doc 000 JDP 10000 OME rev 3 3 13 2102 17A Advanced...
Страница 222: ...NAVIS NavDP 4000 Operation Manual Figure 10 74 Drift Plot Window 221 Doc 000 JDP 10000 OME rev 3 3 13 2102 17A Advanced...
Страница 324: ...NAVIS NavDP 4000 Operation Manual Figure H 4 Remote DLS Mode 323 Doc 000 JDP 10000 OME rev 3 3 13 2102 17A Advanced...
