NAVIS NavDP 4000 Series, Руководство по эксплуатации

Страница: 215 / 348

System Functions
– enter a value for either thrust or power limit in the Limit field.
– press OK softkey to apply all changes and leave the dialog box. In case an incorrect value is set for the component
limits OK softkey is unavailable.
Press
Cancel
to leave the dialog box without any changes.
Figure 10.64: Example of the Dialog Box for Editing the Thrust/Power Limits
When the tie breaker is selected, On/Off softkey is displayed near its name and state instead of “Change” softkey (see
Figure 10.65). Press this softkey to change the tie breaker’s position.
Figure 10.65: Indication of the Tie Breaker’s State
Selection of Hypothetic Environmental Conditions (Wind, Waves and Current)
Current
Press Change softkey to set values for the current direction and speed.
In the opened dialog box (see Figure 10.66):
– select the current direction value:
– enter a new value in degrees in the DIR field or
– press
Hold
softkey to enter present value for the current direction;
– press SPD softkey and enter a new value for the current speed in the corresponding field;
– press OK softkey to apply the choice and leave the dialog box. In case incorrect values are entered for the current
direction/speed, OK softkey is unavailable.
Press Cancel softkey to leave the dialog box without any changes.
The values for current direction and speed set in the dialog box are
displayed under the
Current text.
Doc. 000.JDP-10000-OME, rev.3.3.13/“2102.$–17A-Advanced”
214