Mitsubishi Electric MELSERVO MR-J4-03A6-RJ, Инструкция по эксплуатации

Страница: 529 / 610

11. MR-D01 EXTENSION I/O UNIT
11 - 66
11.7.3 When using a programmable controller for automatic operation with BCD (3 digits × 2) inputs
POINT
The speed change with the analog override function is enabled in both of the
automatic operation mode and manual operation mode. However, it is disabled
under the following conditions.
During home position return
During deceleration or stop with TSTP (Temporary stop/restart)
Based on the position data set with the programmable controller and the selected speed command,
positioning is executed. For a connection example of the programmable controller and servo amplifier, refer
to section 11.5.1 (2) (b).
(1) Parameter setting
Set the parameters to use BCD (3 digits × 2) inputs and STRB (Strobe) with [Pr. Po10]. Refer to the
following table and set the parameters as necessary.
No. Name Setting digit Setting item Setting value Setting
[Pr. Po10]
Function
selection O-1
_ _ _ x Operation method _ _ _ 2
Always set this item.
Enable the input/output devices required for
BCD input. For the devices to be enabled, refer
to section 3.4.
x _ _ _ Strobe 0 _ _ _
Always set this item.
When using a programmable controller, STRB
(Strobe) is required.
_ x _ _
Sign of the
position data for
BCD positioning
_ 0 _ _ 6-digit position data without signs (+/-)
_ 1 _ _
(initial value)
6-digit position data with signs (+/-)
[Pr. PT01]
Command mode
selection
_ _ _ x
Positioning
command method
selection
_ _ _ 0
(initial value)
Absolute value command method
_ _ _ 1 Incremental value command method
[Pr. PT03]
Feeding function
selection
_ _ _ x
Feed length
multiplication
[STM]
Refer to section 7.2.9.
[Pr. PA14]
Rotation
direction
selection/
Travel direction
selection
Servo motor
rotation direction
0 (initial value)
ST1 (Forward rotation start) on: Rotates the
servo motor in the CCW direction.
ST2 (Reverse rotation start) on: Rotates the
servo motor in the CW direction.
1
ST1 (Forward rotation start) on: Rotates the
servo motor in the CW direction.
ST2 (Reverse rotation start) on: Rotates the
servo motor in the CCW direction.
www.kavrammuhendislik.com.tr