Mitsubishi Electric MELSERVO MR-J4-03A6-RJ, Инструкция по эксплуатации

Страница: 526 / 610

11. MR-D01 EXTENSION I/O UNIT
11 - 63
(1) Parameter setting
Set the parameters to use BCD (3-digit × 2) inputs with [Pr. Po10]. Refer to the following table and set
the parameters as necessary.
No. Name Setting digit Setting item Setting value Setting
[Pr. Po10]
Function
selection O-1
_ _ _ x Operation method _ _ _ 2
Always set this item.
Enable the input/output devices required for
BCD input. For the devices to be enabled, refer
to section 11.5.2.
x _ _ _ Strobe
2 _ _ _
(initial value)
STRB (Strobe) is not used.
Do not change the initial value.
_ x _ _
Sign of the
position data for
BCD positioning
_ 0 _ _ 6-digit position data without signs (+/-)
_ 1 _ _
(initial value)
6-digit position data with signs (+/-)
[Pr. PT01]
Command mode
selection
_ _ _ x
Positioning
command method
selection
_ _ _ 0
(initial value)
Absolute value command method
_ _ _ 1 Incremental value command method
[Pr. PT03]
Feeding function
selection
_ _ _ x
Feed length
multiplication
[STM]
Refer to section 7.2.9.
[Pr. PA14]
Rotation
direction
selection/
Travel direction
selection
Servo motor
rotation direction
0 (initial value)
ST1 (Forward rotation start) on: Rotates the
servo motor in the CCW direction.
ST2 (Reverse rotation start) on: Rotates the
servo motor in the CW direction.
1
ST1 (Forward rotation start) on: Rotates the
servo motor in the CW direction.
ST2 (Reverse rotation start) on: Rotates the
servo motor in the CCW direction.
(2) Operation
Set position data with the MR-DS60 (6-digit digital switch) and turn on ST1 (Forward rotation start) to
move the travel distance of the position data in the forward direction with the rotation speed, acceleration
time constant, and deceleration time constant set in the point table selected with SPD1 (Speed selection
1) to SPD4 (Speed selection 4). In the incremental value command method, turning on ST2 (Reverse
rotation start) moves the travel distance in the reverse direction.
Select point tables as follows with SPD1 (Speed selection 1) to SPD4 (Speed selection 4) and execute
the positioning based on the set rotation speed, acceleration time constant, and deceleration time
constant.
In this case, the position data set to the point table is not used.
(Note) Device Selected
Point table No.
SPD4 SPD3 SPD2 SPD1
0 0 0 1 1
0 0 1 0 2
1 1 0 1 13
1 1 1 0 14
1 1 1 1 15
Note. 0: Off
1: On
www.kavrammuhendislik.com.tr