Mindray VS8, Руководство по обслуживанию

Страница: 71 / 156

VS 9/VS 8 Vital Signs Monitor Service Manual
6-1
6
Disassembly and Maintenance
6.1 Disassembly Preparations
Tooling:
 Screwdriver
Preparations:

Make sure that the monitor is turned off and the AC power is disconnected.

Make sure that the desk is clean and tidy, and the touchscreen is not damaged
by any hard objects.
WARNING

Maintenance personnel are required to eliminate static electricity before
disassembly. When removing some parts with the electrostatic sensitive
mark, wear protective devices such as ESD wrist straps or ESD gloves, lest
the parts would be damaged.

Properly connect and route the cables and wires when reassembling the
monitor to avoid short circuits.

Use specified screws to reassemble the equipment. If the incorrect screws
are forcefully tightened, the equipment may be damaged and the screws
or part may fall off during use, causing unpredictable equipment damage
or human injury.

Be sure to follow the correct sequence when disassembling the monitor.

Disconnect all cables before disassembling any parts. Be careful not to
damage any cables or connectors.

Place the removed screws and other parts separately by category so that
they can be used in the reinstallation. Do not drop, contaminate or lose
them.

Place materials by module; otherwise, incorrect material may be used or
corresponding material cannot be founding during reassembly.

Install assemblies before the installation of the main unit. Properly
connect cables and pay attention to the positions where wires are placed.

Make sure that waterproof strips and other waterproof auxiliary materials
are properly assembled.