Kikusui KHA3000, Руководство по эксплуатации, Страница: 372 / 392

Messages
372
KHA3000
SOURce subsystem
STATus subsystem
IEEE488.2 common commands
SCPI command Setting
Default
Response Influence
Description R/W
Note
Program header Parameter Unit
SOUR
:OUTP[:STAT] bool ON | OFF – OFF NR1
ON/OFF of the output of the AC
power supply
R/W 3
:PHAS:ON NRf 0 to 359, -1
DEG
– NR3
Output ON phase of the AC power
supply
R/W 3
:FREQ NRf 50, 60 HZ – NR3 Frequency of the AC power supply R/W 3
:VOLT NRf 0.0 to 305.0 V – NR3
Output voltage of the AC power
supply
R/W 3
:VOLT:RANG NRf 100 | 200 V – NR3
Output voltage range of the AC
power supply
R/W 3
SCPI command Setting
Default
Response Influence
Description R/W
Note
Program header
Parameter Unit
STAT
:OPER
[:EVEN]
– – – – NR1 –
Queries an event.
*1
R 1
:COND
– – – – NR1 –
Queries the register status.
*1
R 1
:ENAB
NRf 0 to 32767 – – NR1 –
Enable
*1
R/W 1
:NTR
NRf 0 to 32767 – – NR1 –
Negative transition
*1
R/W 1
:PTR
NRf 0 to 32767 – – NR1 –
Positive transition
*1
R/W 1
:PRES – – – Initializes the filter register. W 1
:QUES
[:EVEN]
– – – – NR1 –
Queries an event.
*2
R 1
:COND
– – – – NR1 –
Queries the register status.
*2
R 1
:ENAB
NRf 0 to 32767 – – NR1 –
Enable
*2
R/W 1
:NTR
NRf 0 to 32767 – – NR1 –
Positive transition
*2
R/W 1
:PTR
NRf 0 to 32767 – – NR1 –
Negative transition
*2
R/W 1
*1. OPERation status register
*2. QUEStionable status register
IEEE488.2
common
command
Parameter Description R/W
*CLS – Clears all event registers. W
*ESE NR1 Sets the event status enable register bit. R/W
*ESR – Queries the event status register. R
*IDN – Queries the identification string (information on the manufacturer). R
*OPC –
When all operations of the equipment that were detected as in standby are finished, the
equipment generates an operation completion message in the event status register.
R/W
*OPT – Queries the options installed in this product. R
*RST – Resets the equipment to the default state independent of the use history of the equipment. W
*SRE NR1 Sets the service request enable register. R/W
*STB – Queries the contents of the status byte register and master summary status message. R
*TRG – Trigger command W
*TST – Executes self-diagnosis. R
*WAI –
Prevents the equipment from executing any command or query until all operations in
standby are complete.
W