504
Jetter AG
10 Programming
Enabling JX2 system bus special functions
The value of this register influences the behavior at initializing of the
JX2 system bus (CAN 1).
Meaning of the individual bits
Bit 3,
bit 2
Activate CAN-Prim in addition to JX2 system bus
01 =
The CAN-Prim interface and the JX2 system bus are enabled
following the next launch of the JX2 system bus. This requires a
restart of the controller.
This function lets you connect JX2 expansion modules.
Bit 3,
bit 2
Enable CAN-Prim or CANopen® STX API only.
1x =
At the next restart, the JX2 system bus is not initialized. The
CAN-Prim interface can be used.
All node IDs can be used
without any
restrictions.
The controller does not initialize any JX2 expansion modules on
the JX2 system bus. For this reason, JX2 expansion modules
cannot
be connected.
The CANopen® STX API can be used.
Bit 6
1 =
CANopen® support in the JX2 system bus driver is disabled. This
requires a restart of the controller.
If you intend to connect to the JX2 system bus JX2-I/O and
JX2 slave modules along with CANopen® devices, the
communication of which you intend to program via CANopen®
STX API (mixed operation), you must set bit 6.
The JX2 system bus driver supports certain CANopen® devices.
If you intend to connect CANopen® devices which are not
supported and communication of which you intend to program via
CANopen® STX API, you must set this bit to completely disable
the support by the JX2 system bus driver.
If you intend to program communication with CANopen® devices
via CANopen® STX API yourself, only WAGO I/O System 750,
JX-SIO, LioN-S modules, etc. can be connected to the
JX2 system bus.
Bit 6 makes sense only if bit 3 has not been set
Module register properties
Value after reset
Non-volatile; factory setting: 0
Takes effect
Next time when the controller is launched
R 200002077
Содержание JC-120MC
