Jetter AG
121
JC-120MC
Mechanical and electrical installation
Interface cable KAY_0386-xxxx
The interface cable KAY_0386-xxxx lets you connect HMIs of the type LCD 60
to the JC-120MC.
For information on connector specification refer to the list below:
Type
8-pin male MiniDIN connector
Manufacturer
KYCON
Item
KMDLA - 8P
Recommended core cross section
0.128 … 0.051 mm
2
For information on female connector specification refer to the list below:
Type
15-pin female Sub-D connector in
metallized housing (quality grade 3).
Manufacturer
Various manufacturers
Recommended core cross section
0.25 … 0.128 mm
2
For information on cable specification refer to the list below:
Number of cores
5
Recommended core cross section
0.14 mm
2
Maximum cable length
400 m
Complete shielding, no paired shielding
The shield must be connected to the connector housings on both ends of
the cable with the greatest possible surface area.
Place the shield as follows:
•
Connect the shield by its greatest possible surface area.
•
Clamp it under a strain relief.
•
Wrap it with copper foil.
Introduction
Male connector
specification
(controller end)
Female connector
specification (HMI end)
Specifications of
connecting cable
Cable shielding
Содержание JC-120MC
