Jetter JC-120MC, Руководство пользователя

Страница: 129 / 634

Jetter AG 129
JC-120MC Initial commissioning
Configuring error states
JetSym lets you configure the JC-120MC.
The following requirements must be satisfied:

JetSym has been installed on the PC used.
 JetSym has been licensed (see online help in JetSym).
 Limitations to be taken into account when engineering a JX3 station have
been observed.
To successfully commission the controller and the JX3 modules connected to
it, proceed as follows:
Step Action
1
Make sure that the power supply is disconnected!
2 Add the required JX3 modules to form the JX3 station. When engineering
a JX3 station, consider the limitations applying to its setup.
Applying the
JX3 system bus configurator (see page 94)
3
Use an Ethernet cable to connect the controller JC-120MC and the PC.
4
Set an IP address at the controller JC-120MC.
For more information, refer to chapter
IP configuration
(see page 73).
5 On the PC, set an IP address which differs from the IP address of the
controller.
Example: The controller has got IP address 192.168.1.1. Thus, for the PC,
IP address 192.168.1.20 can be used.
Make sure that the first three elements of the IP addresses are identical.
6 Switch on the power supply for the JX3 station.
7
Launch JetSym. Then configure the JX3 station following the sample
program.
For more information on this sample program, refer to chapter
Configuration in JetSym
(see page 130).
8
Configure the JX3 station using the Hardware Manager.
For more information, refer to chapter
Hardware Manager (see page
254).
9
Enter the sample program. Then, upload the program to the controller.
Introduction
Prerequisites
Commissioning steps