Jetter JC-120MC, Руководство пользователя

Страница: 481 / 634

Jetter AG 481
JC-120MC Programming
Sending values
The instruction DisplayValue() allows redirection of values to Device 9 .
This way, values can easily be sent via user-programmable serial interface.
This guide proceeds from the assumption that the following conditions are
met:

The user-programmable serial interface is configured.
 The user is familiar with the options of the instruction DisplayValue()
(refer to the online help which comes with JetSym).
When redirecting instruction DisplayValue() to the user-programmable
serial interface the following restriction applies:

The cursor position will not be evaluated.
To send values via user-programmable serial interface proceed as follows:
Step Action
1 The special registers for formatting the display, which are used in
connection with the instruction DisplayValue() , have to be set to the
desired values.
2
Use the instruction DisplayValue() .
3 Specify Device 9 .
Result: The task waits at this instruction until all characters have been
entered into the transmit buffer.
Introduction
Prerequisites
Restrictions
Sending Values