Jetter JC-120MC, Руководство пользователя

Страница: 566 / 634

566 Jetter AG
11 Automatic copying of controller data
Executing AutoCopy commands
During the boot process in AutoCopy mode the controller executes the
commands contained in the command file.
In AutoCopy mode the following restrictions of controller functions apply:
 The controller does not execute the application program.
 Communication with the controller is not possible.

After terminating the AutoCopy function, restart of the controller is required.
The OS of the controller processes the AutoCopy function in the following
steps:
Step Description
1
The controller opens the command file of the SD card that is specified by
the entry AutoCopyIni in the configuration file /System/config.ini .
2 The controller reads the values from section [OPTIONS] .
3
The controller reads the command and its parameters from the section
[COMMAND_1]
, processes it and writes the results, if any, into the log file.
4 ... n
The controller processes the other commands in ascending order up to
the number given in section [OPTIONS] .
n+1 The controller calculates the statistic values for all command results and
writes them into the log file.
During the boot process of the controller, the OS status LEDs indicate the
following:
Step Description
1
R E D1 D2 SD State
4Hz 4Hz 4Hz 4Hz OFF
Reset
2
R E D1 D2 SD State
1Hz OFF OFF ON OFF
Boot loader is running and is
checking the OS.
Introduction
Restrictions
Executing AutoCopy
commands
LEDs of the JC-120MC in
AutoCopy mode