Jetter JC-120MC, Руководство пользователя

Страница: 417 / 634

Jetter AG 417
JC-120MC Programming
JX3 system bus - Description of non-volatile registers
Non-volatile registers let you configure the JX3 system bus. Any changes to a
non-volatile register become effective only after the JC-120MC has been
re-booted.
I/O dummy modules
Each bit in this register represents an I/O module on the JX3 system bus.
Meaning of the individual bits
Bit 0
Configuration of I/O module 2
0 = I/O module is a dummy module
1 = I/O module is not a dummy module
Bit 1 Configuration of I/O module 3
0 = I/O module is a dummy module
1 = I/O module is not a dummy module
etc. Configuration of I/O module 4 ... 17
0 = I/O module is a dummy module
1 = I/O module is not a dummy module
Module register properties
Value after reset Non-volatile; factory setting: 65535
Takes effect Next time when the controller is launched
Number of retries
This register lets you set the number of retries in accessing the JX3 modules.
Before you make changes to this value consult the hotline at Jetter AG.
Module register properties
Values 1 ... 5
Value after reset Non-volatile; factory setting: 1
Takes effect Next time when the controller is launched
Introduction
R 100002023
R 100002034