Jetter AG
115
JC-120MC
Mechanical and electrical installation
Connecting a display or HMI
There are prefabricated cables for connecting a display or HMI made by
Jetter AG to a JC-120MC. We recommend to use the prefabricated cables
listed in the above table.
Connect the display or HMI via serial interface to jack X11. To do so, apply
connections to interface standard RS-422.
R E
D2
JC
-3
50
Jetter
X14
X15
B
U
S
O
U
T
X19
X61
ET
H
ER
N
ET
SD
-C
A
R
D
X11
S11
SE
R
RUN
STOP
LOAD
PO
W
ER
X10
0V
DC24V
1,5A
Irrespective of the fact that various hardware drivers have been implemented,
only one hardware interface is available.
This means:
While, for example, communication via RS-422 is taking place, simultaneous
and independent communication via RS-232 is not possible.
Connecting a display or
HMI
Interface
Restrictions
Содержание JC-120MC
