Jetter JC-120MC, Руководство пользователя

Страница: 390 / 634

390 Jetter AG
10 Programming
10.11 JX2 system bus
The controller JC-120MC features an internal JX2 system bus master. Several
modules can be connected to the JX2 system bus. Access to these modules is
completely transparent.
The JX2 system bus needs not be configured. The JC-120MC is able to
automatically detect and commission connected modules.
Only the baud rate must be set by the user.

JX2-I/O modules
 JX2 slave modules
 Servo amplifiers JetMove 1xx, JetMove 2xx, and JetMove 6xx
 IP67-I/O modules LioN-S and LJX7-CSL

Third-party CANopen® modules, e.g. valve terminals
Topic Page
Module array and module codes of connected modules ............................ 391
JX2 system bus - Baud rate ........................................................................ 394
Dummy modules on the JX2 system bus ................................................... 396
Monitoring intervals on the JX2 system bus ............................................... 397
JX2 system bus - Description of non-volatile registers ............................... 399
Register description of modules connected to the JX2 system bus ........... 403
Register description - Error logging on the JX2 system bus ....................... 405
Register description - Timeout and interval times for modules on the
JX2 system bus ........................................................................................... 408
Register description - Retry counter for JX2 system bus modules ............. 411
Register description - Versions of JX2 system bus drivers ......................... 412
Introduction
Configuration
Connectable modules
Contents